Hi!
Every year, I try to upgrade, every year I run into trouble doing that... ;-)
Summary: i *seem* to have successfully installed SSOTS 4.14. I tried flipflip's original and the newer mod2 version. It seems to be ok, because it starts, runs and I can use the web UI.
When I try to install LMS 7.9 nightly, I get these errors in copious amounts:
"cannot utime: bad address"
And the install fails. And I can not start LMS.
To make sure, I tried with 7.8.1 nightly - getting the same errors.
And yes, I did try to hack routines.sh, which theoretically forces SSODS to recognize the "9" in the 7.9 version number. no change. (sorry, I am not allowed to post links here yet.)
My TS409 is running firmware 3.3.2 build 0918T - the last one released for it.
Any help would be greatly appreciated, thanks!
Oh, and please go easy on me - I am a windows guy. Linux is hard for me. ;-)
Ps. I will post the same over @ qnap, because I am not sure where this post belongs to.
Every year, I try to upgrade, every year I run into trouble doing that... ;-)
Summary: i *seem* to have successfully installed SSOTS 4.14. I tried flipflip's original and the newer mod2 version. It seems to be ok, because it starts, runs and I can use the web UI.
When I try to install LMS 7.9 nightly, I get these errors in copious amounts:
"cannot utime: bad address"
And the install fails. And I can not start LMS.
To make sure, I tried with 7.8.1 nightly - getting the same errors.
And yes, I did try to hack routines.sh, which theoretically forces SSODS to recognize the "9" in the 7.9 version number. no change. (sorry, I am not allowed to post links here yet.)
My TS409 is running firmware 3.3.2 build 0918T - the last one released for it.
Any help would be greatly appreciated, thanks!
Oh, and please go easy on me - I am a windows guy. Linux is hard for me. ;-)
Ps. I will post the same over @ qnap, because I am not sure where this post belongs to.